Fiber Tip Tweezers Tip Replacement Procedure

FIBER TIP SELF ALIGNING TIP REPLACEMENT PROCEDURE

	(1) Use a small Phillips Screwdriver to remove hex screw holding tweezer tip to handle.
	(2) Remove tweezer tips held by the doll pins into handle.
	(3) Replace with new tweezer tip- inserting tips by doll pins into handle, re-insert hex screw.

Note: All tweezer tips are designed to align with second tip, fully interchangeable, no match required. One tip only can be replaced where new tweezers/tips require one tip change with full alignment (new tip with existing second tip).

Electronics / Medical Device Assembly | Disk Drive Assembly | Life Sciences / Pharmaceutical / Biotech

Ergonomics | ESD Safe | Cleanroom Equipment | Assembly